Edge-Core ES4624-SFP Manual page 301

10.2.2.3.1.12 ipv6 neighbor
Command：ipv6 neighbor <ipv6-address> <hardware-address> interface <
interface-type interface-number>
no ipv6 neighbor <ipv6-address>
Function：Set static neighbor table entry.
Parameters ： Parameter ipv6-address is static neighbor IPv6 address, parameter
hardware-address is static neighbor hardware address, interface-type is Ethernet type,
interface-number is Layer 2 interface name.
Command Mode：Interface Configuration Mode
Default Situation：There is not static neighbor table entry.
Usage Guide： IPv6 address and multicast address for specific purpose and local address
can not be set as neighbor.
Example：Set static neighbor 2001:1:2::4 on port E1/1, and the hardware MAC address
is 00-03-0f-89-44-bc
Switch(Config-if-Vlan1)#ipv6 neighbor 2001:1:2::4 00-03-0f-89-44-bc interface Ethernet
1/1
10.2.2.3.1.13 interface tunnel
Command：[no] interface tunnel <tnl-id>
Function：Create/Delete tunnel.
Parameter：Parameter <tnl-id> is tunnel No.
Command Mode：Interface Configuration Mode
Default ：None
Usage Guide：This command creates a virtual tunnel interface. Since there is not
information such as specific tunnel mode and tunnel source, show ipv6 tunnel does not
show the tunnel, enter tunnel mode after creating, under that model information such as
tunnel source and destination can be specified. NO command is to delete a tunnel.
Example：Create tunnel 1
Switch {Config}#interface tunnel 1
10.2.2.3.1.14 ping6
Command：ping6 [ipv6-address]
Function：Validate the reachability of the network.
Parameter：Parameter ipv6-address is destination IPv6 address.
Default：None
Command Mode： Admin Mode
Usage Guide：ping6 being followed by IPv6 address is the default situation, ping6
function can make settings for parameters of ping packets based on user choice. When
301