Commands For Snmp - Edge-Core ES4624-SFP Manual

<write-string>] [notify <notify-string>]]
no snmp-server group <group-string>
{NoauthNopriv|AuthNopriv|AuthPriv}
7. Configure view
Command
snmp-server view
<oid-string> {include|exclude}
no snmp-server view <view-string>
8. Configuring TRAP
Command
snmp-server enable traps
no snmp-server enable traps
Command: snmp-server
{<ipv4-addr>|<ipv6-addr>}
{v1|v2c|{v3
{NoauthNopriv|AuthNopriv|AuthPriv}}}
<user-string>
no snmp-server host
{<ipv4-addr>|<ipv6-addr>} {v1|v2c|{v3
{NoauthNopriv|AuthNopriv |AuthPriv}}}
<user-string>
9. Enable/Disable RMON
Command
rmon enable
no rmon enable

2.4.3 Commands for SNMP

2.4.3.1 rmon
Command: rmon enable
no rmon enable
Function: Enable RMON; the "no rmon enable" command disables RMON.
Command mode: Global Mode
Default: RMON is disabled by default.
Example 1: Enable RMON
Switch(config)#rmon enable
Explanation
Configure
<view-string>
command is used for SNMP v3.
Explanation
Enable the switch to send Trap message.
This command is used for SNMP v1/v2/v3.
Set the host IPv4/IPv6 address which is
host
used to receive SNMP Trap information.
For SNMP v1/v2, this command also
configures Trap community string; for
SNMP v3, this command also configures
Trap user name and security level.
Explanation
Enable/disable RMON.
77
view on the switch. This