Interface; Preempt-Mode; Priority - Edge-Core ES4624-SFP Manual

Command mode: VRRP protocol configuration mode
Usage Guide: Activates the appropriate Virtual Router. Only a router (or L3 Ethernet
switch) interface started by this enable command is part of Standby cluster. VRRP virtual
IP and interface must be configured first before starting Virtual Router.
Example: Activating the Virtual Router of number 10
Switch(config)# router vrrp 10
Switch(Config-Router-Vrrp)# enable

25.3.6 interface

Commands: interface{IFNAME | Vlan <ID>}
no interface
Function: Configures the VRRP interface
Parameters: interface{IFNAME | Vlan <ID>} stands for the interface name.
Default: Not configured by default.
Command mode: VRRP protocol configuration mode
Usage Guide: This command adds a layer 3 interface to an existing Standby cluster. The
"no interface" command removes the L3 interface from the specified Standby cluster.
Example: Configuring the interface as "interface vlan 1"
Switch(Config-Router-Vrrp)# interface vlan 1

25.3.7 preempt-mode

Commands: preempt-mode{true| false}
Function: Configures the preemptive mode for VRRP
Parameters: N/A.
Command mode: VRRP protocol configuration mode
Default: Preemptive mode is set by default
Usage Guide: If a router (or L3 Ethernet switch) requiring high priority needs to
preemptively become the active router (or L3 Ethernet switch), the preemptive mode
should be enabled.
Example: Setting non-preemptive VRRP mode
Switch(Config-Router-Vrrp)# preempt-mode false

25.3.8 priority

Commands: priority <value>
no priority
Function: Configures VRRP priority; the "no priority" restores the default value 100.
902