Ip Mac-Address Dynamic Maximum - Edge-Core ES4624-SFP Manual

Parameters：<value> upper limit of the number of dynamic MAC address of the port,
ranging from 1 to 4096.
Default Settings：The number limitation function of dynamic MAC address on the port is
disabled.
Command Mode：Port mode.
Usage Guide：When configuring the max number of dynamic MAC address allowed by
the port, if the number of dynamically learnt MAC address on the port is already larger
than the max number of dynamic MAC address to be set, the extra dynamic MAC
addresses will be deleted. This function is mutually exclusive to functions such as dot1x,
MAC binding, if the functions of dot1x, MAC binding or TRUNK are enabled on the port,
this function will not be allowed.
Examples：
Enable the number limitation function of dynamic MAC address in port 1/2 mode, the max
number to be set is 20
Switch(Config)#interface ethernet 1/2
Switch(Config-Ethernet1/2)# switchport mac-address dynamic maximum 20
Disable the number limitation function of dynamic MAC address in port 1/2 mode.
Switch(Config-Ethernet1/2)#no switchport mac-address dynamic maximum

24.3.2 ip mac-address dynamic maximum

Command：ip mac-address dynamic maximum <value>
no ip mac-address dynamic maximum
Function：Set the max number of dynamic MAC address allowed in the VLAN, and, at
the same time, enable the number limitation function of dynamic MAC address in the
VLAN; "no ip mac-address dynamic maximum" command is used to disable the number
limitation function of dynamic MAC address in the VLAN.
Parameters：<value> upper limit of the number of MAC address in the VLAN, ranging
from 1 to 4096.
Default Settings：The number limitation function of dynamic MAC address in the VLAN
is disabled.
Command Mode：Interface mode.
Usage Guide：When configuring the max number of dynamic MAC allowed in the VLAN,
if the number of dynamically learnt MAC address in the VLAN is already larger than the
max number to be set, the extra dynamic MAC addresses will be deleted. After enabling
number limitation function of dynamic MAC in the VLAN, the number limitation of MAC is
only applied to general access port, the number of MAC on TURNK ports and special
ports which has enabled dot1x, MAC binding function will not be limited or counted.
Examples：
886