Gvrp Troubleshooting; Dot1Q-Tunnel Configuration; Dot1Q-Tunnel Introduction - Edge-Core ES3628EA User Manual

Switch(Config-Vlan100)#exit
Switch(Config)#interface ethernet 0/0/11
Switch(Config-Ethernet0/0/11)#switchport mode trunk
Switch(Config-Ethernet0/0/11)# bridge-ext gvrp
Switch(Config-Ethernet0/0/11)#exit
Switch B:
Switch(Config)# bridge-ext gvrp
Switch(Config)#interface ethernet 0/0/10
Switch(Config-Ethernet0/0/10)#switchport mode trunk
Switch(Config-Ethernet0/0/10)# bridge-ext gvrp
Switch(Config-Ethernet0/0/10)#exit
Switch(Config)#interface ethernet 0/0/11
Switch(Config-Ethernet0/0/11)#switchport mode trunk
Switch(Config-Ethernet0/0/11)# bridge-ext gvrp
Switch(Config-Ethernet0/0/11)#exit
Switch C:
Switch(Config)# bridge-ext gvrp
Switch(Config)#vlan 100
Switch(Config-Vlan100)#switchport interface ethernet 0/0/2-6
Switch(Config-Vlan100)#exit
Switch(Config)#interface ethernet 0/0/11
Switch(Config-Ethernet0/0/11)#switchport mode trunk
Switch(Config-Ethernet0/0/11)# bridge-ext gvrp
Switch(Config-Ethernet0/0/11)#exit

5.2.5 GVRP Troubleshooting

The GARP counter setting in for Trunk ports in both ends of Trunk link must be the
same, otherwise GVRP will not work properly.It is recommended to avoid enabling
GVRP and RSTP at the same time in ES3628EA switch. If GVRP is to be enabled,
RSTP function for the ports must be disabled first.

5.3 Dot1q-tunnel Configuration

5.3.1 Dot1q-tunnel Introduction

164