Edge-Core ES4624-SFP Manual page 789

Parameter: vlan-id: vlan id, valid range: <1-4094>
value：query interval, valid range: <1-65535>secs.
Command Mode: Global Mode
Default: 255s
Usage Guide:This command can only be configured on L2 general querier. The
Suppression-query-time represents the period the suppression state maintains when
general querier receives queries from layer 3 MLD within the segment. To use this
command, the query-intervals in different switches within the same segment must be in
accordance. It is recommended to use the default value.
Example:
Switch(config)#ipv6 mld snooping vlan 2 suppression-query-time 270
21.4.3.13 show ipv6 mld snooping
Command: show ipv6 mld snooping [vlan <vlan-id>]
Parameter: <vlan-id> is the number of vlan specified to display the MLD Snooping
messages
Command Mode: Admin Mode
Usage Guide: If no vlan number is specified, it will show whether the global MLD
snooping is enabled and layer 3 multicast protocol is running, as well as on which vlan
the mld snooping is enabled and configured l2-general-querier. If a vlan number is
specified, the detailed MLD Snooping messages of this vlan will be displayed.
Example:
Summary of the switch MLD snooping
Switch(config)#show ipv6 mld snooping
Global mld snooping status: Enabled
L3 multicasting:
Mld snooping is turned on for vlan 1(querier)
Mld snooping is turned on for vlan 2
--------------------------------
Displayed Information
Global mld snooping status
L3 multicasting
Mld snooping is turned on for
vlan 1(querier)
running
Explanation
Whether or not the global mld snooping is enabled on
the switch
Whether or not the layer 3 multicast protocol is running
on the switch.
On which vlan of the switch is enabled mld snooping,
if the vlan are l2-general-querier.
789