Commands For Pim-Sm - Edge-Core ES4624-SFP Manual

20.3.3 Commands for PIM-SM

20.3.3.1 ip pim accept-register
Command: ip pim accept-register list <list-number>
no ip pim accept-register
Function: Filter the specified multicast group and multicast address.
Parameter: <list-number>: <list-number> is the access-list number ,it ranges from 100
to 199.
Default: Permit the multicast registers from any sources to any groups.
Command Mode: Global Mode
Usage Guide: This command is used to configure the access-list filtering the PIM
REGISTER packets.The addresses of the access-list respectively indicate the filtered
multicast sources and multicast groups' information. For the source-group combinations
that match DENY, PIM sends REGISTER-STOP immediately and does not create group
records when receiving REGISTER packets. Unlike other access-list, when the
access-list is configured ,the default value is PERMIT.
Example: Configure the filtered register message's rule to myfilter.
Switch(config)#ip pim accept-register list 120
Switch (config)#access-list 120 deny ip 10.1.0.2 0.0.0.255 239.192.1.10 0.0.0.255
Switch (config)#
20.3.3.2 ip pim bsr-candidate
Command: ip pim bsr-candidate {vlan <vlan-id>| <ifname>} [hash-mask-length]
[priority]
no ip pim bsr-candidate
Function: This command is the candidate BSR configure command in global mode and
is used to configure PIM-SM information about candidate BSR in order to compete the
BSR router with other candidate BSRs. The command "no ip pim bsr-candidate"
disables the candidate BSR.
Parameter: Ifname is the specified interface's name;
[hash-mask-length] is the specified hash mask length. It's used for the RP enable
selection and ranges from 0 to 32;
[priority] is the candidate BSR priority and ranges from 0 to 255. If this parameter
is not configured ,the default priority value is 0.
Default: This switch is not a candidate BSR router.
Command Mode: Global Mode
Usage Guide: This command is the candidate BSR configure command in global mode
674