Arp Scanning Prevention Troubleshooting Help - Edge-Core ES4624-SFP Manual

In the network topology above, port e4/1 of SWITCH B is connected to port e4/19 of
SWITCH A, the port e4/2 of SWITCH A is connected to file server (IP address is
192.168.1.100/24), and all the other ports of SWITCH A are connected to common PC.
The following configuration can prevent ARP scanning effectively without affecting the
normal operation of the system.
SWITCH A configuration task sequence:
SwitchA(config)#anti-arpscan enable
SwitchA(config)#anti-arpscan recovery time 3600
SwitchA(config)#anti-arpscan trust ip 192.168.1.100 255.255.255.0
SwitchA(config)#in e4/2
SwitchA (Config-If-Ethernet4/2)#anti-arpscan trust port
SwitchA (Config-If-Ethernet4/2)#ex
SwitchA(config)#in e4/19
SwitchA (Config-If-Ethernet4/19)#anti-arpscan trust supertrust-port
Switch A(Config-If-Ethernet4/19)#ex
SWITCH B configuration task sequence:
Switch B(Config)# anti-arpscan enable
SwitchB(config)#in e4/1
SwitchB (Config-If-Ethernet4/2)#anti-arpscan trust port
SwitchB (Config-If-Ethernet4/2)ex

15.5 ARP Scanning Prevention Troubleshooting Help

ARP scanning prevention is disabled by default. After enabling ARP scanning
prevention, users can enable the debug switch, "debug anti-arpscan", to view debug
information.
If the state of a port is showed as not closed when using "show anti-arpscan", it
means that the port is not closed by the ARP scanning prevention function. If the port is
closed by other modules, users can check it with "show interface".
The max number of IP that can be disabled by IP-based ARP scanning prevention is
64. If the limit is exceeded, users will see a prompt. Other modules can also disable IP,
since the max number of IP that can be disabled by the switch is 256, if this limit is
exceeded, a prompt will also be returned.
397