Show - Edge-Core ES4624-SFP Manual

on the path receives this datagram, it minus the HOPLIMIT by 1 and the HOPLIMIT is
now 0. So the router will discard this datagram and returns with a 「ICMPv6 time
exceeded」 message (including the source address of the IPv6 packet, all content in the
IPv6 packet and the IPv6 address of the router). Upon receiving this message, the
Traceroute6 sends another datagram of which the HOPLIMIT is increased to 2 so to
discover the second router. Plus 1 to the HOPLIMIT every time to discover another router,
the Traceroute6 repeat this action till certain datagram reaches the destination.
Traceroute6 Options and explanations of the parameters of the Traceroute6
command please refer to traceroute6 command chapter in the command manual.

2.2.7 Show

show command is used to display information about the system , port and protocol
operation. This part introduces the show command that displays system information,
other show commands will be discussed in other chapters.
Admin Mode
show calendar
show debugging
dir
show history
show memory
show running-config
show startup-config
show
switchport[ethernet
<interface-list>]
show tcp
show udp
Display current system clock
Display the debugging state
Display the files and the sizes saved in the
flash
Display
command
Display content in specified memory area
Display the switch parameter configuration
validating at current operation state.
Display the switch parameter configuration
written in the Flash Memory at current
operation
configuration file applied in next time the
switch starts up
Display the VLAN port mode and the
interface
belonging VLAN number of the switch as well
as the Trunk port information
Display
established currently on the switch
Display
established currently on the switch
59
the recent user
state, which is
the TCP connection
the UDP connection
input history
normally the
status
status