Dot1X Max-User Userbased; Dot1X Port-Control - Edge-Core ES4624-SFP Manual

Default: The default maximum user allowed is 1.
Usage Guide: This command is available for ports using MAC-based access
management, if MAC address authenticated exceeds the number of allowed user,
additional users will not be able to access the network.
Example: Setting port 1/3 to allow 5 users.
Switch(Config-Ethernet1/3)#dot1x max-user macbased 5

23.3.10 dot1x max-user userbased

Command：dot1x max-user userbased <number>
no dot1x max-user userbased
Function：Set the upper limit of the number of users allowed to access the specified port
when using user-based access control mode; the "no dot1x max-user userbased"
command is used to reset the default value .
Parameters：<number> the maximum number of users allowed to access the network,
ranging from 1 to 1~128.
Command Mode：Interface Mode.
Default Settings：The maximum number of users allowed to access each port is 128 by
default.
User Guide： This command can only take effect when the port adopts user-based access
control mode. If the number of authenticated users exceeds the upper limit of the number
of users allowed to access the network, those extra users can not access the network.
Examples：Set the maximum number of users allowed to access the network on port
Ethernet 3 as 5.
Switch(Config-Ethernet 3)#dot1x max-user userbased 5

23.3.11 dot1x port-control

Command: dot1x port-control {auto|force-authorized|force-unauthorized }
no dot1x port-control
Function: Sets the 802.1x authentication status; the "no dot1x port-control" command
restores the default setting.
Parameters: auto enable 802.1x authentication, the port authorization status is
determined by the authentication information between the switch and the supplicant;
force-authorized sets port to authorized status, unauthenticated data is allowed to pass
through the port; force-unauthorized will set the port to non-authorized mode, the switch
will not provide authentication for the supplicant and prohibit data from passing through
the port.
Command mode: Port configuration Mode
859