Commands For Mld - Edge-Core ES4624-SFP Manual

ipv6 mld
<time_val>
no ipv6 mld query-interval
ipv6
query-max-response-time
<time_val>
no ipv6
query-max-response-time
ipv6 mld
<time_val>
no ipv6 mld query-timeout
3. Shut down MLD Protocol
Command
Port Configuration Mode
no ipv6 pim dense-mode | no ipv6
pim sparse-mode | no ipv6 pim
multicast-routing (Global Mode)

21.3.3 Commands for MLD

21.3.3.1 ipv6 mld access-group
Commandipv6 mld access-group {<acl_name>}
no ipv6 mld access-group
Function: Configure the access control of the interface to MLD groups ;the "no ipv6 mld
access-group" command stops the access control
Parameter: <acl-name> is the name of IPv6 access-list
Default: no filter condition
Command Mode: Interface Configuration Mode
Usage Guide: Configure the interface to filter MLD groups, allow or deny some group's
join.
Example: Configure the interface vlan2 to accept group FF1E::1:0/112 and deny others
Switch (Config)# ipv6 access-list aclv6 permit FF1E::1:0/112
Switch (Config)# ipv6 access-list aclv6 deny any
Switch (Config)#interface vlan 1
Switch(Config-If-Vlan1)#ipv6 mld access-group aclv6
21.3.3.2 ipv6 mld immediate-leave
Configure
query-interval
messages sent periodically; the NO operation
of this command restores the default value.
Configure the maximum response time of the
mld
interface for MLD query; the NO operation of
this command restores the default value.
mld
Configure the overtime of the interface for
query-timeout
MLD query; the NO operation of this
command restores the default value.
Explanation
Shut down MLD Protocol
773
the interval of MLD query