Debug Mrpp; Enable - Edge-Core ES4624-SFP Manual

Default： None
Usage Guide： The command specifies Virtual VLAN ID of MRPP ring, currently it can
be any value in 1-4094.To avoid confusion, it is recommended that the ID is
non-configured VLAN ID, and the same to MRPP ring ID. In configuration of MRPP ring
of the same MRPP loop switches, the control VLAN ID must be the same, otherwise the
whole MRPP loop may can't work normally or form broadcast.
Example： Configure control VLAN of mrpp ring 4000 is 4000.
Switch(Config)# mrpp ring 4000
Switch(mrpp-ring-4000)#control-vlan 4000

26.3.3 debug mrpp

Command :debug mrpp
no debug mrpp
Function： Open MRPP debug information; "no description" command disables MRPP
debug inforamation
Command Mode： Admin Mode
Parameter： None
Usage Guide： Enable MRPP debug information, and check message process of MRPP
protocol and receive data package process, it is helpful to monitor debug.
Example： Enable debug information of MRPP protocol.
Switch#debug mrpp

26.3.4 enable

Command：enable
no enable
Function： Enable configured MRPP ring, the"no enable" command disables this
enabled MRPP ring.
Parameter：
Command Mode： MRPP ring mode
Default： Default disable MRPP ring.
Usage Guide： Executing this command, it must enable MRPP protocol, and enable all
of option needed to be configured of the MRPP ring.
Example： Configure MRPP ring 4000 of switch to primary node, and enable the MRPP
ring.
Switch(Config)# mrpp enable
Switch(Config)# mrpp ring 4000
Switch(mrpp-ring-4000)#control-vlan 4000
914