Typical Sntp Configuration Examples; Web Management; Snmp/Ntp Server Configuration - Edge-Core ES4624-SFP Manual

14.3 Typical SNTP Configuration Examples

SwitchA
All ES4624-SFP/ES4626-SFP switch in the autonomous zone are required to perform
time synchronization, which is done through two redundant SNTP/NTP servers. For time
to be synchronized, the network must be properly configured. There should be reachable
route between any ES4624-SFP/ES4626-SFP switch and the two SNTP/NTP servers.
Example: Assume the IP addresses of the SNTP/NTP servers are 10.1.1.1 and 20.1.1.1,
respectively, and SNTP/NTP server function (such as NTP master) is enabled, then
configurations for any ES4624-SFP/ES4626-SFP switch should like the following:
Switch#config
Switch(Config)#sntp server 10.1.1.1
Switch(Config)#sntp server 20.1.1.1
From now on, SNTP would perform time synchronization to the server according to the
default setting (polltime 64s, version 1).

14.4 Web Management

Click "SNTP configuration" to open the switch SNTP configuration management list.
Users may then make configuration to switch's SNTP settings.

14.4.1 SNMP/NTP server configuration

Click "SNTP configuration", "SNTP/NTP server configuration" to configure SNTP/NTP
server address and server version.
Example: Configure Server address as 10.1.1.1, configure version as 4, and then, Click
Apply button to apply the configuration to switch.
SNTP/NTP Server
SwitchB
Fig 11-2 Typical SNTP Configuration
SNTP/NTP Server
SwitchC
386