Commands For Pim-Dm6 - Edge-Core ES4624-SFP Manual

PIM-DM switch on relevant interface.
Command
Global Mode
ipv6 pim multicast-routing
And then turn on PIM-DM switch on the interface
Command
Port Configuration Mode
ipv6 pim dense-mode
2. Configure PIM-DM Auxiliary Parameters
（1）Configure PIM-DM Interface Parameters
Configure PIM-DM hello message interval time
Command
Port Configuration Mode
ipv6 pim hello-interval < interval>
no ipv6 pim hello-interval
Command
Port Configuration Mode
ipv6 pim state-refresh
origination-interval
no ipv6 pim state-refresh
origination-interval
3. Shut down PIM-DM Protocol
Command
Port Configuration Mode
no ipv6 pim dense-mode
Global Mode
no ipv6 pim multicast-routing

21.1.3 Commands for PIM-DM6

Explanation
Enable PIM-DM
commands are required to really function
PIM-DM protocol )
Explanation
Start PIM-DM Protocol of the interface
(Required)
Explanation
Configure PIM-DM hello message interval
time; the NO operation of this command
restores the default value.
Explanation
Configure PIM-DM state-refresh message
interval time; the NO operation of this
command restores the default value.
Explanation
Turn off PIM-DM protocol of the interface
Shut down PIM-DM Protocol in global mode.
734
Protocol (but below