Table of Contents
Advertisement
Replacement
1. Remove the VPD module from the old operator panel and insert it in the new
operator panel. Make sure you insert the module in the same position as it was in
the old panel.
1
2
2. Replace in reverse order.
Operator Panel Cable
Removal
1. Power off the system (see "Powering Off and Powering On the System" on page 9).
2. Disconnect the ac power cord from the system.
3. Remove the front cover to access the operator panel (see "Removing the Covers"
on page 311).
4. Pull the knobs on each side of the operator panel to unlock it.
5. Pull the operator panel outward from the system.
6. Loosen the thumbscrews that hold the cable restraint plate to the operator panel.
7. Slide the restraint plate to the back of the operator panel.
8. Disconnect the cable from the back of the operator panel.
9. Disconnect the cable from the system board
Replacement
1. Replace the operator panel cable by reversing the steps in the removal procedure.
2. Power on the system (see "Powering Off and Powering On the System" on page 9).
PCI Adapter Dividers
Removal
1. Remove all PCI adapters (see "Removing Adapter Cards" on page 329).
2. Gently twist down the flexible tab on the right end of the divider.
2
VPD Module
Cable Connector
1
Chapter 9. Removal and Replacement Procedures
353
Advertisement
Table of Contents
