Removal/installation routines
Installing/removing a SCSI hard disk module
Removing/inserting the dummy cover
Ê Push the cover of the accessible drives up as far as it will go using both
thumbs (1). You will feel a certain resistance (the cover clicks into place
again about half a centimeter above the locked position).
Ê Remove the cover toward you (2).
To insert the drive cover, follow the instructions above in reverse order.
If you want to install a hard disk drive in a bay which has never contained one,
you must remove the dummy cover beforehand.
U41057-J16-Z146-1-76
SCSI hard disk subsystem
1
2
October 2003
02
TX600
85
–
–