Installing/Removing A Floppy Disk Drive - Fujitsu PRIMERGY TX600 User Manual

Accessible drives and operating panel

Installing/removing a floppy disk drive

Requirements
Floor-standing model
– Server has been switched off
– Power cords have been disconnected
– Front cover has been removed (see
– Right side cover has been removed (see
– Peripheral cover has been removed (see
– Fan box has been removed (see
– Peripheral cage has been removed (see
Rack model
– Server has been switched off
– Power cords have been disconnected
– Rack model has been pulled out
– Peripheral cover has been removed (see
– Fan box has been removed (see
– Peripheral cage has been removed (see
Ê Unlock the plug and disconnect the flat foil cable.
Ê Pull the snap-on mounting out a little (1).
Ê Pull the drive out of the peripheral cage (2).
Installation is performed in reverse order.
02 TX600 102
– –
Removal/installation routines
page 02-TX600-76)
page
page
page 02-TX600-115)
page
page
page 02-TX600-115)
page
2
October 2003
02-TX600-77)
02-TX600-82)
02-TX600-97)
02-TX600-82)
02-TX600-97)
1
U41057-J16-Z146-1-76