Fujitsu PRIMERGY TX600 User Manual page 141

Removal/installation routines
Processors
The D1411 system board has four sockets of type 603 and can be upgraded
with further processors.
You may only use processors of the same type on the system board.
!
All additional processors must have the same clock rate and cache
size as the first one.
If multiprocessor operation is required, you must use a suitable mul-
tiprocessor operating system.
Processors are components which are extremely sensitive to electro-
static discharges and must therefore be handled with caution.
After removing a processor from its protective wrapper or from a
socket, place it on an insulated, antistatic surface with the smooth
side down.
Never slide a processor over a surface.
Installing/removing processors
Requirements
Floor-standing model
– Server has been switched off
– Power cords have been disconnected
– Front cover has been removed (see
– Right side cover has been removed (see
– Main cover has been removed (see
– Ventilation duct has been removed (see
Rack model
– Server has been switched off
– Power cords have been disconnected
– Rack model has been pulled out
– Main cover has been removed (see
– Ventilation duct has been removed (see
U41057-J16-Z146-1-76
page 02-TX600-77)
page 02-TX600-77)
page 02-TX600-81)
page 02-TX600-138)
page 02-TX600-81)
page 02-TX600-138)
October 2003
System board
02 TX600 141
– –