Fujitsu PRIMERGY TX600 User Manual page 126

Boards in PCI slots
The PCI board is attached to a separating plate (see figure above with an
RX600 server for example).
Ê Take the separating plate by the grooved surface (a), and pull it together with
the PCI board out of the PCI slot (1).
Do not pull at the PCI board.
!
When removing the PCI board from the separating plate, pay special
attention to the snap-fits holding it attached to the separating plate
(see page
Do not lift them more than approx. 1 mm, i.e. only wide enough to
have the PCI board released. Otherwise the snap-fits could be
damaged.
02 TX600 126
– –
1
02-TX600-127).
October 2003
Removal/installation routines
U41057-J16-Z146-1-76
a