Remoteview Chipdisk - Fujitsu PRIMERGY TX600 User Manual

Installation and initial operation
Write protection for floppy disks - switch 6
Switch 6 is used to define whether floppy disks can be written to or deleted in
the floppy disk drive. To allow writing to and deletion of floppy disks, the write-
protection in the BIOS setup must be disabled (in the Security menu, the Diskette
Write field must be set to Enabled).
on The floppy disk drive is write-protected.
Floppy disks can be read, written to and deleted (default setting).
off
Skipping the password query - switch 7
Switch 7 is used to define whether the password is queried at system startup, if
the password protection is enabled in BIOS Setup (in the Security menu, the
Password field must be set to Enabled).
The password query is effective.
on
The password query is skipped. Passwords are deleted (default setting).
off
Recovering system BIOS - switch 8
Switch 1 enables recovery of the old system BIOS after an update attempt has
failed. To restore the old system BIOS you need a Flash BIOS floppy disk.
on The system boots from the Flash BIOS floppy disk from drive A and
reprograms the system BIOS on the board.
The System BIOS is started with the system BIOS from the system board
off
(default setting).

RemoteView chipDISK

To be able to use RemoteView, the remote test and diagnostics system, on the
server, a RemoteView
TX600. The chipDISK has an IDE interface and is mounted directly in the (X23)
plug (next to the DVD port) on the system board (see also
U41057-J16-Z146-1-76
chipDISK is optionally available for the PRIMERGY
October 2003
Settings
page 02-TX600-43).
02 TX600 53
– –