Table of Contents
Advertisement
Installing/removing the rack model
Ê Using the supplied Allen key (no. 5), secure the two telescopic rails in the
rack with two M5 screws each on the right and left support uprights.
Note that the guide nubs of the telescopic rails next to the spring nuts must
engage in the holes in the support uprights.
Ê Mount the server (see
Mounting the articulated cable carrier (cable management)
n contrast to the instruction in the technical manual for the 19-inch
!
(Classic) rack, the articulated cable carrier is fastened only to the support
upright - not to the server.
Ê To secure the articulated cable carrier, place two spring nuts in the groove
of the rear right support upright in the rack. The mounting height must match
the height of the cables connected to the server.
02
TX600
180
–
–
page
02-TX600-185).
October 2003
Removal/installation routines
U41057-J16-Z146-1-76
Advertisement
Table of Contents
