Fujitsu PRIMERGY TX600 User Manual page 50

Settings
The PCI interrupts are assigned automatically in accordance with the
Auto
Plug&Play guidelines.
Disabled No ISA interrupt is assigned to the PCI interrupt.
0, 1, 2, 3, 4, 5, 6, 7, 9, 10, 11, 12, 13, 14, 15, 22, 23
The selected ISA interrupt is assigned to the PCI interrupt. You may
not select an ISA interrupt that is used by a component on the system
board (e.g. controller) or an ISA board.
When the Auto setting is selected, you can check the interrupt assign-
i
ments using the ICU (ISA Configuration Utility).
A
Slot 1 PCI IRQ line 0
Slot 2 PCI IRQ line 8
Slot 3 PCI IRQ line 14
Slot 4 PCI IRQ line 12
Slot 5 PCI IRQ line 4
Slot 6 PCI IRQ line 2***
PCI IRQ line 2
VGA IRQ 19
COP A PCI IRQ line 16
SCSI* PCI IRQ line 22
LAN A** PCI IRQ line 20
LAN B** -
A...D = Interrupt output of the PCI controller
* : Interrupts of SCSI channel A or B.
** : LAN interrupts are not PCI-specific.
***: In the case of the ZCR, the interrupts 22 and 23 are disabled
02 TX600 50
– –
B C
PCI IRQ line 1 PCI IRQ line 6
PCI IRQ line 9 PCI IRQ line 10
PCI IRQ line 15 PCI IRQ line 12
PCI IRQ line 13 PCI IRQ line 14
PCI IRQ line 5 PCI IRQ line 6
PCI IRQ line 3*** PCI IRQ line -***
PCI IRQ line 3 PCI IRQ line 22
- -
PCI IRQ line 17 PCI IRQ line 18
PCI IRQ line 23 -
- -
PCI IRQ line 21 -
October 2003
Installation and initial operation
D
PCI IRQ line 7
PCI IRQ line 11
PCI IRQ line 13
PCI IRQ line 15
PCI IRQ line 7
PCI IRQ line -***
PCI IRQ line 23
-
PCI IRQ line19
-
-
-
U41057-J16-Z146-1-76