Fujitsu PRIMERGY TX600 User Manual page 174

Installing/removing the rack model
Procedure for telescopic rails type 2
For mounting the server in the PRIMECENTER rack you will need the following
parts from the rack mounting kit S26361-F2734-L36:
– Support bracket
– Two telescopic rails (assembled)
– Eight fixing brackets
When mounting the left telescopic rail in the PRIMECENTER rack, the supplied
support bracket must first be mounted on the rear left support upright such that
it is level with the lower edge of the server.
Ê See the assembly instructions in the technical manual for the
PRIMECENTER rack.
For better orientation the height units are marked on the support
i
uprights.
Ê Mount the support bracket at the appropriate height on the left rear support
upright as described in the technical manual for the PRIMECENTER rack.
You do not need flange nuts to fasten the telescopic rails because the fasteners
have threaded holes. For fixing in position, two fixing brackets each must be pre-
mounted on the support uprights and the support bracket:
Ê Place the fixing brackets (1) in the holes of the support upright or support
bracket at the attachment points marked.
02 TX600 174
– –
1
October 2003
Removal/installation routines
U41057-J16-Z146-1-76