Table of Contents
Advertisement
Power Supply
Power Supply
In the basic configuration, the server is equipped with two hot-plug power supply
modules.
Replacing a hot-plug power supply module
If a defective hot-plug power supply module is not replaced immediately,
!
it must be left in the device until its replacement.
Requirements
– None
An individual hot-plug power supply module can be replaced during oper-
i
ation.
Removing a hot-plug power supply module
Ê Pull the power cable out of the grounded power outlet and out of the
defective hot-plug power supply unit.
Ê Push the locking lever in the direction of the arrow (1) and pull the hot-plug
power supply module out of its slot.
02
TX600
108
–
–
Removal/installation routines
2
1
October 2003
U41057-J16-Z146-1-76
Advertisement
Table of Contents
