Table of Contents
Advertisement
Installation and initial operation
PCI bus resources
PCI slots
PCI
Voltage Frequency
slot
in MHz
1
5 V
33
2
3.3 V
100
3
3.3 V
100/133
4
3.3 V
100/133
5
3.3 V
133
6
3.3 V
100
*) If there is only one controller present on either slot 3 or 4, this can be operated at 133 MHz.
PCI slot 6 and the SCSI controller are connected to the same bus.
i
Using an "Adaptec 2000 S (ZCR) Controller", a RAID solution can be
implemented. For this purpose, this controller must only be installed in
PCI slot 6.
PCI IRQ Line x - assignment of the PCI interrupts
PCI IRQ Line x defines which ISA interrupts are used for the separate PCI slots.
If you select Auto in the BIOS setup, the interrupts are assigned automatically
and no further settings are required.
Multifunctional PCI boards or boards with an integrated PCI-to-PCI bridge can
use several PCI interrupts (INTA#, INTB#, INTC#, INTD#). Monofunctional PCI
boards (default) only use one PCI interrupt (INTA#) per PCI slot.
The PCI interrupts INTA#, INTB#, INTC# and INTD# are available for each PCI
slot.
The same interrupt can be assigned simultaneously to several PCI boards. You
should avoid this condition due to reduced performance.
If you use a setting other than Auto, the Plug&Play functionality of the system
BIOS for the corresponding PCI boards is deactivated.
U41057-J16-Z146-1-76
Hot-
PCIX Description
plug
no
no
64-bit PCI bus slot
yes
yes
64-bit PCI bus slot (primary)
yes
yes
64-bit PCI bus slot (secondary))
yes
yes
64-bit PCI bus slot (secondary)
yes
yes
64-bit PCI bus slot (secondary)
no
yes
64-bit PCI bus slot (up to 340 mm),
prepared for ZCR (= Zero-Channel
RAID) controller, primary
October 2003
Settings
02
TX600
49
–
–
Advertisement
Table of Contents
