Fujitsu PRIMERGY TX600 User Manual page 133

Removal/installation routines
1
1
When removing the supporting plate from the separating plate, pay
!
special attention to the snap-fits holding it attached to the separating
plate. Do not lift them more than approx. 1 mm, i.e. only wide enough to
have the supporting plate released. Otherwise the snap-fits could be
damaged.
Ê Lift the green movable snap-fits not more than approx. 1 mm, until the
supporting plate is released (1). Take the supporting plate off (2), and put it
aside.
Keep the supporting plate for future use. If you remove the board and
i
it is not replaced with a new one, you must reinstall the dummy cover
together with the separating plate to comply with cooling require-
ments.
Ê Slide the snap-fits downwards, until they are released from the separating
plate (see page
U41057-J16-Z146-1-76
2
02-TX600-128), and keep them.
October 2003
Boards in PCI slots
02 TX600 133
– –