Removal/installation routines
Boards in PCI slots
Each PCI slot of the server must be occupied by either a PCI board or a
!
dummy module, which is a supporting plate attached to a separating
plate.
Before installing or removing a board, please read the documentation
i
supplied with it.
The hot-plug function is supported by the currently available operating systems
Novell NetWare 5.0 and 5.1. For the Windows NT 4.0 and Windows 2000
operating systems the necessary components are provided with the installation
of the ServerView Agent.
Replacing a (hot-plug) PCI board
Only PCI boards of the same type and with the same settings may be
i
exchanged. If the boards do not match, the new board will not be
commissioned.
Requirements
Floor-standing model
– Server has been switched off
– Power cords have been disconnected
– Front cover has been removed (see
– Right side cover has been removed (see
Rack model
– Server has been switched off
– Power cords have been disconnected
– Rack model has been pulled out
U41057-J16-Z146-1-76
page
02-TX600-76)
page
02-TX600-77)
October 2003
Boards in PCI slots
02
TX600
123
–
–