Fujitsu PRIMERGY TX600 User Manual page 30

Initial operation and operating
Indicators on the control panel
Power-on indicator (bicolor)
Glows orange when the server is switched off but mains voltage is
present (standby mode).
Glows green when the server is switched on.
Flashes orange when the server is in standby mode again after a power
failure.
Indicator drive active (green)
Glows only when the optional chipDISK is being accessed.
Global Error Indicator (orange)
Does not light up if the system is ok, i.e. the power is ON, no service
?
incident or critical event has occurred
Flashes orange if a critical event has occurred. Users can check BIOS
Setup, system- and event log or via ServerView for event details. The
indicator also flashes in standby mode.
Glows orange if a prefailure event has been recognized. Users can
check system- and event log or via ServerView for event details. The
indicator does also light up in standby mode.
If the event is still acute after a power failure, the indicator is
activated after the restart.
i
ID ID indicator (blue)
Glows blue when the system has been selected by pressing the ID
button. To deactivate, press the ID button again.
The ID indicator can also be activated via ServerView or its status is
reported to ServerView.
LCD display field (LocalView module)
The LCD display shows system information and hardware system errors
(see also
02 TX600 30
– –
To reset the Global Error LED proceed as follows:
Reboot the system. If the LED status should remain unchanged,
consult the system event log in ServerView or the BIOS menu
Advanced Settings - IPMI and solve the problem specified there.
Reboot the system.
page 02-TX600-31).
October 2003
Installation and initial operation
.
U41057-J16-Z146-1-76