Installing And Removing Drives In A 3½ Inch Bay At The Front Of The Device; Installing And Removing A 3½ Inch Hard Disk Drive In A 3½ Inch Bay At The Front Of The Device - Fujitsu PRIMERGY MX130 S1 Operating Manual

1
2
► Connect the power supply connector.
► Replace the cross-piece (see "Installing the cross-piece").
► Close the casing (see "Closing the casing").
If necessary, in the BIOS Setup, modify the entry for the drive as appropriate.
i
Installing and removing drives in a 3½ inch bay at the
front of the device
Installing and removing a 3½ inch hard disk drive in a 3½ inch
bay at the front of the device
Removing hard disk(s)
► Open the casing (see "Opening the casing").
► Remove the cross-piece (see "Removing the cross-piece").
► Fold up the drive cage (see "Folding up the drive cage").
Fujitsu Technology Solutions
3
► Fold down the power supply in the
direction of the arrow (1) until the power
supply engages.
► Press on the locking lug (2) of the drive
cage and then fold down the drive cage
applying light pressure in the direction of
the arrow (3) until the drive cage
engages.
Make sure that the cables are not kinked or
pinched.
System expansions
61