Retrofitting To An Existing D3 Foundation Plate - Centurion D2 Turbo Installation Manual

Option 3: Retrofitting D2 Turbo to a n existing D3 foundation plate.
1. Grind off the existing mounting studs
from the D3 foundation plate as shown
in Figure 21.
2. Fit the three mounting studs to the
D2 Turbo foundation plate and secure in
place using the stud locknuts supplied
with this kit. The half-height nuts should
be used on the underside of the plate as
shown in Figure 22, as these will later be
used for height adjustment. However, if
space allows – i.e. there will be sufficient
clearance between the rack and the
pinion once the operator has been
mounted – the orange height-adjustment
nuts may be used.
Do not attempt to mount the gearbox without using either the half-
height nuts or the orange jacking nuts as doing so will result in the
gearbox being damaged when the hold-down nuts are tightened.
page 25