Centurion D2 Turbo Installation Manual page 75

Step 4: Return the Function Dial to the RUN
position.
Please note that PIRAC Mode can
be active in addition to this mode if
so desired.
22.7. Setting PIRAC Mode
PIRAC (Beam Autoclose) Mode can be activated when using any of the three Operating
Modes (Standard, Open Only, or Reversing).
To select PIRAC Mode as either On or Off, please follow the steps below:
Step 1: Rotate the Function Dial to the
MODE position (D).
Step 2: Rotate the Setting Dial to the PIRAC
on/off selection along the 'D' row of options.
Step 3: Press the pushbutton to toggle
between On and Off.
The Status LED will change from red to
green indicating that PIRAC Mode has been
activated, or it will change to red indicating
that PIRAC Mode has been deactivated.
page 71
FIGURE 121.
FIGURE 122.
FIGURE 123.