Do you have a question about the D3 and is the answer not in the manual?
Questions and answers
jeffrey
March 10, 2025
why the motor doesn't read the limit 2 after programing it only goes ones not the second time then shows limits failed
1 comments:
Mr. Anderson
March 10, 2025
The Centurion D3 motor may not read limit 2 after programming and may show "limits failed" due to an issue with the limit switch mechanism. Possible reasons include:
1. Tamper-Proof Limit Switch Issue – The internal limit switch may not be correctly detecting the gate's position. 2. Encoder or Sensor Problem – The high-resolution encoder wheel and opto-electronic sensor may not be functioning properly, leading to inaccurate position detection. 3. Improper Programming – If the initial programming was not completed correctly, the motor may not recognize the limit positions. 4. Mechanical Obstruction or Alignment Issue – If the gate has been moved manually without proper re-engagement, the system may not detect the correct limits.
To resolve this, check the sensor alignment, reprogram the limits, and ensure there are no obstructions affecting movement.
Need help?
Do you have a question about the D3 and is the answer not in the manual?
Questions and answers
why the motor doesn't read the limit 2 after programing it only goes ones not the second time then shows limits failed
The Centurion D3 motor may not read limit 2 after programming and may show "limits failed" due to an issue with the limit switch mechanism. Possible reasons include:
1. Tamper-Proof Limit Switch Issue – The internal limit switch may not be correctly detecting the gate's position.
2. Encoder or Sensor Problem – The high-resolution encoder wheel and opto-electronic sensor may not be functioning properly, leading to inaccurate position detection.
3. Improper Programming – If the initial programming was not completed correctly, the motor may not recognize the limit positions.
4. Mechanical Obstruction or Alignment Issue – If the gate has been moved manually without proper re-engagement, the system may not detect the correct limits.
To resolve this, check the sensor alignment, reprogram the limits, and ensure there are no obstructions affecting movement.
This answer is automatically generated