Commissioning The System; Setting Up The Gate Limits - Centurion D2 Turbo Installation Manual

20. Commissioning the System

Introduction
The D2 Turbo and D2 Turbo Low-Voltage sliding gate operators' advanced functions
are controlled by intelligent microcontroller-based electronic controllers. These systems'
features and functions are enabled and disabled using the two user-friendly setting dials,
with the top dial used for selecting the desired function, and the bottom dial used for
selecting the specific setting to be enabled or disabled.

Setting up the gate Limits

1. Ensure that the gate is in the fully closed
position and the motor drive is engaged.
2. Rotate the Function Dial to the LIMITS
position along the 'A' row of options.
3. Rotate the Setting Dial to the SETUP
position along the 'A' row of options.
4A. Press the pushbutton to select this
feature.
SETUP: SETUP:
Step 1: Select FUNCTION
Step 2: Select SETTING
Step 3: Press
Step 4: When finished
select RUN
www.centsys.com
page 47
Close
the gate
FIGURE 67.
Aux 12V
Safe Com
Com
Safe OPN
Safe CLS
FUNCTION LCK/STP
TRG
PED
Aux I/O
Com
LED
A B C D E
SETTING
FIGURE 68.