Centurion D2 Turbo Installation Manual page 40

9. With Nylon Angle rack it is necessary to
use the bracket provided.
10. It is preferable to use self-tapping
fasteners to secure the bracket into the
side of the nylon rack as shown.
11. Make a small tack weld to secure the
back of the bracket onto the angle iron
section of the rack.
12. Bolt the origin marker onto the bracket
using the fasteners provided.
13. Note the orientation of the origin marker.
14. Manually slide the gate open until the
origin marker is in line with the origin
sensor.
15. Ensure distance between the face of
marker and front face of the sensor is
between 13mm and 20mm.
16. Adjust distance by sliding the origin
marker along the slotted mounting holes
until the specified distance is achieved.
For best results keep gap between marker and sensor as small as
possible.
Nylon angle rack
Bolt using
fasteners
provided
Origin marker
bracket
13mm-20mm
Origin sensor
page 36
Screw into
the side of the nylon rack
FIGURE 52.
Gate
Rack
FIGURE 53.
Origin marker
Gate
Rack
FIGURE 54.