Centurion D2 Turbo Installation Manual page 76

Step 4: Return the Function Dial to the RUN
position.
22.8. Setting the Pre-flashing Modes
Pre-flashing Mode A and Pre-flashing Mode C can be activated in addition to any of the
above Modes of Operation.
To select a Pre-flashing Mode as either on or off, please follow the steps below:
Step 1: Rotate the Function Dial to the
MODE position (D).
Step 2: Rotate the Setting Dial to either PFA
on/off for Pre-flash Mode A, or PFC on/off for
Pre-flash Mode C along the 'C' row of
options.
Step 3: Press the pushbutton to toggle the
Pre-flash Mode between On and Off.
The Status LED will change from red to
green indicating that the selected Pre-flash
Mode has been activated, or it will change to
red indicating that it has been deactivated.
Step 4: Return the Function dial to the RUN
position.
page 72
FIGURE 124.
FIGURE 125.
FIGURE 126.
FIGURE 127.