CHAPTER 4 RADIO COMMUNICATIONS
Introduction
This chapter provides information about the modes of operation and features available for wireless
communication between digital scanners, cradles and hosts. The chapter also includes the parameters
necessary to configure the digital scanner.
The digital scanner ships with the settings shown in the
(also see
Appendix A, Standard Default Parameters
defaults). If the default values suit requirements, programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in
non-volatile memory and are preserved even when the digital scanner is powered down.
If not using a Synapse or USB cable with the cradle, select a host type (see each host chapter for specific host
information) after the power-up beeps sound. This is only necessary upon the first power-up when connected
to a new host.
To return all features to default values, scan a default bar code in
the programming bar code menus, default values are indicated with asterisks (
Scanning Sequence Examples
In most cases, scan one bar code to set a specific parameter value.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
*
Enable Pair on Contacts
*
Indicates Default
Radio Communication Default Parameters on page 4-2
for all host device and miscellaneous digital scanner
Default Parameters on page
Feature/Option
5-5. Throughout
*
).