Selecting Beeper Volume Using Trigger; Led Definitions - Motorola DS9208 Product Reference Manual

2 - 4 DS9208 Product Reference Guide

Selecting Beeper Volume using Trigger

The digital scanner emits a short beep when it successfully reads a bar code. To change the volume of the
beep either scan the appropriate bar code in
Press and hold the trigger for an extended period of time (5 seconds by default - see
1.
Trigger Timeout on page 4-8
Medium, Low) emitting a 2-beep tone at each setting.
To select a particular setting, release the trigger after you hear the desired 2-beep tone.
2.

LED Definitions

In addition to beep sequences, the digital scanner uses a two-color LED to indicate status.
LED colors that display during scanning.
Standard LED Definitions
Table 2-2
LED
Presentation Mode
Green
Momentarily Off
Red
Off
Trigger Mode
Green
Red
Off
Image Capture
Blinking Green
None
Parameter Programming
Green
Red
ADF Programming
Green
Blinking Green
Beeper Volume on page
to change this). The digital scanner cycles through three settings (High,
The scanner is on and ready to scan.
A bar code was successfully decoded.
Transmission error, conversion or format error, or RS-232 receive error.
No power is applied to the digital scanner, or the scanner is in low power mode.
A bar code was successfully decoded.
Transmission error, conversion or format error, or RS-232 receive error.
No power is applied to the digital scanner, or the scanner is on and ready to scan.
Snapshot mode started.
Snapshot mode completed or timed out.
Number expected. Enter value using numeric bar codes.
Successful program exit with change in parameter setting.
Input error: incorrect bar code, programming sequence, or Cancel scanned.
Enter another digit. Add leading zeros to the front if necessary.
Enter another alphabetic character or scan the End of Message bar code.
All criteria or actions cleared for current rule, continue entering rule.
Delete last saved rule. The current rule is left intact.
All rules deleted.
Enter another criterion or action, or scan the Save Rule bar code.
4-7, or use the trigger as follows:
Indication
Volume Adjustment
Table 2-2 defines