Selecting The Video Input Using The F1 To F4 (Function) Buttons On The Remote Commander; Switching The Sound To Be Sent To The Remote Party; Switching Video And Audio At The Same Time; Switching The Picture From The Remote System - Sony Ipela PCS-XG80S Operating Instructions Manual

The stored video input is not deleted even after the system is turned off, and
is selected when the power is turned on again.
To change the video input name displayed in the Video Input menu
You can label the desired name for each video input on the Custom Input Label
page in the Video setup menu. When you switch the video input in step 2
above, the name you set is displayed in the Video Input menu.
For example, you can label: Camera1, Camera2, None, etc.
For details, see"Custom Input Label" in the Video setup menu on page 73.
Selecting the Video Input Using the F1 to F4 (Function) Buttons on
the Remote Commander
If you assign the video input (Camera, S-VIDEO, RGB or YPbPr) to any of the
F1 to F4 buttons on the Remote Commander in "Function Keys in
Communication" of the General setup menu, you can quickly switch the video
input only by pressing one of the F1 to F4 buttons.
For details, see "Function Keys in Communication" in the General setup
menu on page 83.

Switching the Sound to Be Sent to the Remote Party

You can switch the sound sent to the remote party between the sound from the
microphone and that from the connected equipment. Use "Audio Input" in the
Audio setup menu.
For details, see "Audio Input" in the Audio setup menu on page 70.

Switching Video and Audio at the Same Time

Set "Link to Audio Input" to "On" on the Link to Mic page of the Video setup
menu. When you switch the video input, the audio input automatically
switches to the one which has been set to link to the switched video input.
For details, see"Link to Audio Input" in the Video setup menu on page 73.

Switching the Picture from the Remote System

You can switch the picture output from the remote system during
communication.
Press the VIDEO INPUT button, then F1 button on the Remote Commander.
The Video Input > Far menu appears.
Selecting the Input Picture and Sound
143