Turning Off; Adjusting The Volume On The Tv Monitor - Sony IPELA PCS-G70 Operating Instructions Manual

Note
When the Communication Terminal and the Camera are separately installed, point the
Remote Commander to the Camera for operations.
To cancel setting the system to standby
Select "Cancel" with the B or b button on the Remote Commander, then press
the PUSH ENTER button in step 2 above.
To release the standby mode
Press any button on the Remote Commander.
To specify the standby time
Specify the time that you want the system to remain on before entering into
standby mode (1 to 99 minutes) by selecting "Device Setup" on the General
Setup menu, and then setting "Standby Time". If you do not want the system
to enter the standby mode, set "Standby Mode" to "Off".
For the "Standby Time" and "Standby Mode" settings, see "General Setup
Menu" on page 59

Turning Off

1
Put the system into standby mode.
2
Open the front panel of the Communication Terminal, and then slide the
power switch on the right to the off position ( ).
3
Turn off the power of other equipment used for the videoconference.
Note
Set the power switch on the Communication Terminal off when the system will not be
used for an extended period. While the power switch is off, you cannot receive a call
from a remote party.

Adjusting the Volume on the TV Monitor

Before adjusting the volume on the TV monitor, set the volume on the
Communication Terminal to the appropriate position.
1
Press the VOLUME +/– buttons on the Remote Commander to set the
volume level on the adjustment bar displayed on the screen to the middle
position.
Turning the System On/Off
37