Sony IPELA PCS-G70 Operating Instructions Manual page 160

To change the settings
Set "Monitors" in "Monitor Out" of the Video Setup menu to "3". Next, you
must select the connector where the second monitor is connected. To do so, set
"Monitor" in "Monitor Out" of the Video Setup menu to "SUB". Once the
settings are changed, the first monitor displays video, while the second and
third display video or still images.
For details, see "To change the images displayed in a triple monitor setup" on
this page.
To view the picture as a window picture
When you press the PinP button of the Remote Commander during
communication, the picture appears as a smaller window picture over the
display of the first monitor.
Note
You cannot perform this operation on the second and third monitors.
To change the images displayed in a triple monitor setup
You can display the following on the monitors during communication in a
triple monitor setup.
Main monitor
FAR/NEAR
button
In this setup, each time that you press the DISPLAY button on the Remote
Commander, the entire display structure changes in sequence.
Main monitor
You can display remote camera video.
Sub monitor 1
You can display local camera video, received or transmitted still images, or
remote camera video.
Each time that you press the DISPLAY button of the Remote Commander, the
display changes.
160
Using Multiple Monitors
Sub monitor 1
Local
camera
Remote
camera 1
Remote
camera 1
Local
camera
Sub monitor 2
Local
camera
Still
image
Remote
camera 2
(Only during
dual video
reception)
Local
camera
RGB
picture
Picture
on
whiteboard