Sony IPELA PCS-G70 Operating Instructions Manual page 54

Auto: Select when connecting a remote
party via a normal ISDN line.
56K: Select when connecting a remote party
located in a region or country where the
ISDN transmission rate is 56 Kbps.
Note
The system is set to connect an ISDN line at the
transmission rate of 64 Kbps by default.
However, some countries, such as the USA,
and some regions may use the ISDN
transmission rate of 64 Kbps and 56 Kbps. You
may not communicate with such countries or
regions at 64 Kbps, so you must therefore set
"Restrict" to "56K" before dialing.
Page 3/3
H.239 Presentation
Dual Video
Far End Camera Control
Allows you to select whether to enable the
control of each other's cameras from each
other's site.
If you set "Individual Settings" to "On" on page
1 of the Communication Setup menu, you can
perform this setting individually for transmission
and reception.
On: Enables the control of each other's
cameras. This is the default setting.
Off: Disables the control of each other's
cameras.
T.120 Data
Allows you to select whether to perform data
conferences with the T.120 standard using
NetMeeting (only for ISDN connections). If you
set "Individual Settings" to "On" on page 1 of the
Communication Setup menu, you can perform
this setting individually for transmission and
reception.
On: Enables T.120 data conferences.
Off: Disables T.120 data conferences.
54
Registering Local Information
For details about T.120 data conferences,
see "Conducting a Data Conference Using
NetMeeting – T.120 Data Conference" on
page 176.
H.239 Presentation
Allows you to select whether you can use the
presentation mode based on the H.239
standard. If you set "Individual Settings" to
"On" on page 1 of the Communication Setup
menu, you can perform this setting
individually for transmission and reception.
On: Enables the presentation mode based on
the H.239 standard.
Off: Disables the presentation mode based
on the H.239 standard.
Dual Video
Allows you to select whether you can use the
dual video function based on the H.239
standard.
If you set "Individual Settings" to "On" on
page 1 of the Communication Setup menu,
you can perform this setting individually for
transmission and reception.
If H.239 presentation is set to "Off", the dual
video option does not display.
On: Enables the dual video function based
on the H.239 standard.
Off: Disables the dual video function based
on the H.239 standard.
Page 4/4
This page is only displayed when MCU
software (page 210) is installed.
Multipoint Mode
Allows you to select whether to conduct
multipoint videoconferences.