Preparing The System; Attaching The Remote Control Receiver - Sony IPELA PCS-G70 Operating Instructions Manual

Preparing the System

Attaching the Remote Control Receiver

Most operations with the Video Communication System can be controlled
with the supplied Remote Commander. To use the Remote Commander, point
it to the supplied remote control receiver or the remote sensor on the Camera
Unit. Connect the remote control receiver to the CTRL-S jack on the
Communication Terminal. Use the supplied Velcro to fix the remote control
receiver to a monitor, etc.
For details on connecting the Camera Unit, see "System Connections" on
page 29.
TERMINAL VISCA OUT
AUDIO OUT AUDIO IN
(MIXED)
AUX LINE MIC
(PLUG IN POWER)
1 2
5
1 2
EC-MIC RGB OUT
ROL
CTRL-S 1 2
AUX MONITOR
VIDEO OUT
to CTRL-S
Notes
• Be careful not to hide the surface incorporating the
sensor of the remote control receiver.
• When an inverter type or brightness-adjustable type of fluorescent lamp is used in a
conference room, the sensitivity of the Remote Commander may deteriorate. If the
Remote Commander does not function, attach the supplied filter over the remote
sensor of the remote control receiver or change the location of the remote control
receiver to avoid direct light.
• The remote control receiver and the remote sensor of the Camera Unit do not function
at the same time. When the remote control receiver is connected, the remote sensor of
the Camera Unit becomes inactive.
• To operate the camera when the Remote Control Receiver is not in use, point the
remote commander at the connected camera.
MAIN SUB
CAMERA AUX IN CAMERA AUX IN
WHITE 100BASE-TX/
BOARD 10BASE-T
DSB
ISDN UNIT
TV monitor
Remote sensor
indicator, which is the remote
Preparing the System
31