System Connections; System Connection Via A Lan - Sony IPELA PCS-G70 Operating Instructions Manual

System Connections

This section describes the typical system connections.
Notes
• Be sure to turn off all the equipment before making any connections.
• Do not connect/disconnect the camera cable or the interface cable with the power on.
Doing so may damage the Camera Unit, Communication Terminal or ISDN Unit.
• For safety, do not connect the 100BASE-TX/10BASE-T connector to a network that
applies an excess voltage via the 100BASE-TX/10BASE-T connector.
• Used with an ISDN Unit for the first time, the Communication Terminal may
automatically upgrade the software of the ISDN Unit. While the upgrading message
is displayed on the monitor screen, be sure not to turn off the Communication
Terminal. Doing so may cause malfunction of the system.

System Connection via a LAN

PCS-A1 Microphone**
MCU VIDEO OUT
1 2 3 4
DC 19.5V IR OUT
AUX CONTROL
1 2
to
AUDIO
OUT
to DC19.5V
Audio cable*
* supplied
** not supplied
to MIC 1 to MAIN CAMERA
AUDIO OUT AUDIO IN MAIN
(MIXED) AUX LINE MIC CAMERA AUX IN
(PLUG IN POWER)
1 2
5
WHITE 100BASE-TX/
1 2
EC-MIC RGB OUT BOARD 10BASE-T
CTRL-S 1 2
AUX MONITOR
VIDEO OUT
to to 100BASE-TX/
VIDEO OUT
10BASE-T
MONITOR 1
S-video cable*
UTP cable (category 5, straight)**
to
S-video
input
to audio input
TERMINAL VISCA OUT
to TERMINAL
Camera cable
(supplied with the Camera Unit)*
PCS-PG70/PG70P
SUB
CAMERA AUX IN
Communication
DSB
ISDN UNIT
Terminal
PCS-AC19V6
AC adaptor
TV monitor**
to a wall outlet
System Connections
PCSA-CG70/CG70P
Camera Unit**
Power cord*
to a wall outlet
to LAN
29