Sony IPELA PCS-G70 Operating Instructions Manual page 35

Launcher menu
Notes
• After the power is turned on, the camera moves automatically for trial operation. Be
careful not to catch your finger.
• If you use force to prevent the camera moving, it may not resume moving and not
output a signal to the Communication Terminal. In this case, turn off the terminal, and
turn it on again.
• When you turn on the power of the Communication Terminal for the first time after
installation, the setup wizard will appear after the self-diagnosis is completed. Set up
your system following the wizard.
For setups using the wizard, see "Setting Up the System for the First Time
— Initial Setup Wizard" on page 39.
• Used with an optional device especially designed for use with this system, such as the
Data Solution Box or ISDN Unit, for the first time, the Communication Terminal may
automatically upgrade the software of the connected device. While the upgrading
message is displayed on the monitor screen, be sure not to turn off the Communication
Terminal. Doing so may cause malfunction of the system. System malfunction may
also occur when a system power-off has been caused by an accidental problem such
as a power interruption during upgrading. If connection of the Data Solution Box or
ISDN Unit to the Communication Terminal is not re-established even after the system
power is recovered, consult a Sony dealer.
Turning the System On/Off
35