Sony IPELA PCS-G70 Operating Instructions Manual page 284

Message
Connection with the Data Solution Box is
not correct. Please reset the system.
Fan in the Data Solution Box does not work
properly. The Data Solution Box is not
usable.
The Whiteboard cannot be used.
Battery in the stylus could be weak. Replace
the battery.
The far-end system is not compatible with
the encryption feature.
The encryption feature on a far-end system
is disabled.
The encryption feature on a far-end system
is enabled.
The entered password for the encryption
feature is not correct.
The encrypted videoconference is not
available if any terminal is connected via
ISDN.
At least thirteen characters are required as a
password for the encryption feature.
PPPoE connection has failed.
PPPoE server admission has failed.
Connection to the PPPoE server fails.
Communication via LAN is not available.
Check the LAN cable.
An IP address is not obtained via DHCP.
Please dial by entering the IP address.
Reference to DNS has failed.
Your system attempts to connect to other
equipment than a videoconferencing system.
284
On-screen Messages
Meaning
Connection between the Communication Terminal
and the Data Solution Box is not correct. Turn off
the Communication Terminal, then turn it on again.
The fan equipped with the Data Solution Box is not
working properly. You cannot use the Data Solution
Box.
A videoconference with the whiteboard can be held
only when the remote party uses the PCS-G70/
G70P, PCS-1/1P, PCS-11/11P, or PCS-TL50/
TL50P.
The battery in the stylus for the whiteboard is low.
Replace the battery in the stylus with a new one.
When conducting an encrypted videoconference,
you cannot connect to the system that is not
compatible with the encryption feature.
When conducting an encrypted videoconference,
you cannot connect to the system if the encryption
feature is deactivated.
When conducting a daily conference, you cannot
connect to the system if the encryption feature is
activated.
Enter the correct password.
While conducting a videoconference via an ISDN
connection, you cannot connect to any terminal via
LAN connection if "SONY encryption" is being
used.
You have to enter 13 to 20 characters, numbers or
symbols as the password required for conduct of an
encrypted videoconference.
LAN connection has failed. Check the PPPoE
setting.
Access to a network is not admitted by the PPPoE
server.
Check the DNS server setting.
The connection to a LAN cannot be made. Check
the LAN cable.
Check the DHCP setting.
Be sure to enter the IP address of the remote party
when dialing.
The LAN connection has failed as you entered the
user name when using the domain name server.
Enter the IP address.
Connect your system to the videoconferencing
system.