Starting An Encrypted Videoconference - Sony IPELA PCS-G70 Operating Instructions Manual

Starting an Encrypted Videoconference

You can start an encrypted videoconference by calling a remote party in the
same manner as a daily videoconference.
During an encrypted videoconference, the encryption icons,
displayed.
When the signal encryption method is set to "SONY encryption", the
displays, and the
Note
If there is no icon displayed, transmitted and received data is not being encrypted.
Confirm if an icon is displayed before starting a conference.
When the encrypted videoconference is disabled
If the following message appears when you call a remote party, an encrypted
videoconference is not available.
Error Messages
The encryption feature on a far-
end system is disabled.
The entered password for the
encryption feature is not correct.
The encrypted videoconference is
not available if any terminal is
connected via ISDN.
The conference could not start
because the encryption feature at
the near-end side was disabled.
The conference could not start
because the encryption feature at
the far-end side was disabled.
icon displays when "Standard encryption" is set.
Causes
The encryption feature on the remote system is
disabled.
The password entered on the remote system is
not the same as that on the local system.
While the videoconference is held via an ISDN
connection, you cannot connect any terminal via
the LAN connection if your encryption via LAN
feature is activated.
The encryption feature on the local system is
disabled.
The encryption feature on the remote system is
disabled.
Starting an Encrypted Videoconference
or , are
icon
201