General Setup Menu - Sony IPELA PCS-G70 Operating Instructions Manual

IR 2: Allows you to enter the name
displayed when "IR 2" is selected in the
Video Input Select screen (up to 12
characters).
AUX2: Allows you to enter the name
displayed when "AUX2" is selected in
the Video Input Select screen (up to 12
characters).
Monitor Out
Monitors
Allows you to specify the number of
monitors connected to the system.
1: One monitor connected.
2: Two monitors connected.
3: Three monitors connected.
Connection
Select the connector(s) used to connect the
monitor(s).
VIDEO 1: Select when the monitor is
connected to the VIDEO 1 connector.
VIDEO 2: Select when the monitor is
connected to the VIDEO 2 connector.
RGB OUT: Select when the monitor is
connected to the RGB OUT connector of
the main unit.
RGB OUT (DSB): Select when the monitor
is connected to the RGB OUT connector
of the Data Solution Box.
Monitor
Select whether to use the connected monitor
as the sub- or main monitor.
Main: The connected monitor is used as the
main monitor.
Sub: The connected monitor is used as a
sub-monitor.

General Setup Menu

The following menus appear when you
select "General" on the Setup menu for
the administrator. Select the desired
menu.
Device Setup Page 1/2
General Setup
Device Setup
Page: 1/2
Clock Set
Terminal Name PCS-G70
Standby Mode
Standby Time
Last Number Registration
Control by Far End
Clock Set
Enter the current date and time.
Terminal Name
Input the terminal name transmitted to
remote parties (up to 30 characters).
Standby Mode
Allows you to select whether the
Communication Terminal enters standby
mode if idle for a specified period of time.
On: Allows the system to go on standby.
Off: Does not allow the system to go on
standby.
Registering Local Information
11/30/2003 19:25:53
Off
minutes
On
On
Save Cancel
59