Sony IPELA PCS-G70 Operating Instructions Manual page 40

4
Use the V, v, B or b button on the
Remote Commander to select "Next",
then press the PUSH ENTER button.
The ISDN Setup Wizard appears when
the PCSA-B384S, PCSA-B768S or
PCSA-PRI ISDN Unit is connected.
When the ISDN Unit is not connected,
the LAN Setup Wizard is displayed.
Proceed to step 11.
5
Set the following items on the ISDN
line.
ISDN Setup Wizard
Country/Region
Protocol
CRC4
Previous
Country/Region: Select your country
or region.
Protocol: Select the protocol of the
ISDN line you are using.
CRC4: Select whether to enable CRC4.
This option should normally be
enabled.
Note
The "CRC4" option appears when using
the PCSA-PRI.
6
Use the V, v, B or b button to select
"Next", then press the PUSH ENTER
button.
7
Enter the telephone number of the
ISDN used by the system.
When you use one ISDN line, enter the
same number both in the A1 and A2 text
boxes (except for the USA and Canada).
40
Setting Up the System for the First Time — Initial Setup Wizard
USA
National ISDN
On
Next Cancel
Area Code: Enter the area code. Do not
enter the first "0" number.
Local Number: Enter the telephone
number.
Notes
• When you select a blank text box and
press the PUSH ENTER button on the
Remote Commander, the content in the
text box immediately above will be
copied to the selected text box.
• When you use the PCSA-B384S ISDN
unit and connect 2 or 3 ISDN lines,
enter the telephone numbers in the B1
to C2 text boxes in addition to the A1
and A2 boxes.
• When you use the PCSA-B768S and
connect 2 to 6 ISDN lines, enter the
telephone numbers in the B1 to F2 text
boxes in addition to the A1 and A2
boxes. To open the menu with D1 to
F2 text boxes, select "Next", then
press the PUSH ENTER button.
• When you use the PCSA-PRI, Ch1 to
Ch23 (T1), or Ch1 to Ch30 (E1) are
displayed. Enter the telephone
numbers according to the number of
channels you will use.
ISDN Setup Wizard
Area Code Local Number
Ch1
Ch2
Ch3
Ch4
Ch5
Ch6
Previous Next Cancel