Tally Dascom 7006 User Manual page 123

3. Slide the right side platen bearing into its plastic snap. Ensure the platen rotates in
its bearings. There will be a small amount of resistance due to the gears and the
motor.
4. Install the front bezel according to the description in the bezel installation section
(see page 11-15).
5. Slightly spread the front of the enclosure, and begin sliding it forward on the base.
Ensure that the green ground wire at the right is not jammed.
C l e a n i n g a n d P r e v e n t i v e M a i n t e n a n c e
11-13