Installing The Card Cage And I/O Panels - Sun Microsystems StorEdge A7000 Service Manual

5.3

Installing the Card Cage and I/O Panels

FIGURE 5-1
the two bottom 6U openings. Use the opening closest to the rear of the machine, to
cable the HDSA power supply taps to the DC/DC converter.
1. Remove the faceplates from the two 6U openings on the mounting plate in the I/O
bay cabinet.
2. Insert the rear of the card cage through the opening. Align the frame assembly
bracket with the screw holes on the mounting plate. See
3. Attach the frame assembly bracket to the mounting plate, using the four screws
for the bracket.
4. For ease of cabling, unscrew and remove all the blank panels from the card cage.
5. Install the I/O panels in the opening above the card cage.
Two 6U openings
with faceplates
Install I/O panels here
Install card cage here
FIGURE 5-1
shows the I/O bay cabinet. The TMI 10-slot 6U card cage installs in one of
6U Openings in the I/O Bay Cabinet
FIGURE 5-2
I/O bay cabinet
(doors and power cords
not shown)
Chapter 5 Installing the RDC FORM Hardware
.
5-3